DIAMOND PROTECH PRO 36 PROTECTIVE COATING 50ML

Why buy this product?
Ultra smooth feeling and high level of caramel gloss shine.
Diamond hard scratch resistant.
Repels oil, liquids and dirt.
Gives 3 years of hydrophobic protection.

About this product
Diamond ProTech Pro 36 is a protective coating that lasts up to 36 months. Diamond ProTech Pro 36 offers an ultra smooth feel, amazing gloss and a long lasting hydrophobic surface. Diamond ProTech Pro 36 can last for up to three years and will repel oil, liquids and dirt, this will make sure that your car stays clean longer, is easier to clean and always has an amazing shine.

Diamond ProTech’s Pro Line requires training and is exclusively available for certified PRO installers.

Note
- Apply in temperatures between 10-30°C.
- Apply in a closed, well ventilated indoor area with air humidity not exceeding 70%.
- Wear protective gloves.
- Use new applicators & microfiber towels for application of additional layers (do not use previously used towels).

Products you need for applying Diamond ProTech Pro 36
- 2 microfiber towel.
- 1 Applicator.
- Protective gloves.
- Diamond Body Prep.

Application tips from Diamond ProTech
- If applying in high temperature or humidity, lower time between application and removal.
- Test over a small area to determine appropriate time to let the coating bond to the surface.
- Apply to body, headlights, rubber, and metal trim.
- As the coating bonds to the surface a haze will appear. This indicates coating is ready to remove.
- If product dries on the surface or is difficult to remove, re-wet the area with more product and immediately buff off.
- If a second layer is desired, allow to cure for 1 hour before application.

How to use
- Wash, polish and treat the car body with Diamond Body Prep.
- Shake the Diamond ProTech Pro 36 bottle thoroughly for 15 seconds.
- Place 15 drops on an applicator.
- Apply to 1-2 sections of the car in a crosshatch fashion.
- Wait 5-10 mins watching for a haze to appear, then gently buff the treated areas and buff off excess with a low-nap microfiber towel.
- If a second layer is desired, allow to cure for 1 hour before application.
- Allow to cure for 1 hour before using the vehicle.

Specifications