DIAMOND PROTECH PRO 60 HYBRID POLYMER COATING 30ML

Why buy this product?
Up to 5 years protection.
Layerable, Hybrid Polymer Coating.
Diamond Hard Scratch Resistance.
Mirror-Like Gloss and Finish.

About this product
Diamond ProTech PRO 60 is a composite of inorganic polysilazane infused with millions of nano diamond particles. This composition creates one of the most extreme scratch-resistant coatings available on the market.

Note
- Apply in temperatures between 10-30°C.
- Apply in a closed, well ventilated indoor area with air humidity not exceeding 70%.
- Wear protective gloves.
- Use new applicators & microfiber towels for application of additional layers (do not use previously used towels)
.

Products you need for applying Diamond Pro 60
- 3 Microfiber Towels
- 2 Applicators
- Protective Gloves
- Diamond Body Prep

Application tips from Diamond ProTech:
- If applying in high heat or high humidity, lower time between application and removal. Test over a small area to determine appropriate time to let the coating bond to the surface.
- Apply PRO 60 to body, headlights, rubber, and metal trim.
- Apply PRO HYDRO to body, headlights, and metal trim, but not to rubber/plastic.
- PRO 60/PRO HYDRO: As the coating bonds to the surface a haze will appear. This indicates the coating is ready to remove. If product dries on the surface or is difficult to remove, re-wet the area with more product and immediately buff off.

Infra Red Curing Lamp settings
- Temperature: 50-60C
- Distance to Paintwork: 60-70 cm
- Time: 15-20 minutes for each element

How to use
- Wash, polish and treat areas to be coated with Diamond Body Prep.
- Shake PRO 60 well for 15 seconds. Place 15 drops on an applicator and apply to 1-2 sections of the car in a crosshatch fashion. Wait 1-3 mins watching for a haze to appear, then gently buff the treated areas and buff off excess with a low-nap microfiber towel.
- Wait one hour and then apply a second coat repeating the process.
- Wait one hour and apply a coat of PRO HYDRO that will give the coating system its amazing hydrophobicity. If curing with IR lamps, do so prior to applying PRO HYDRO.
- Shake PRO HYDRO well for 15 seconds and then apply 15 drops on an applicator. Apply on 3-4 sections of the car in a crosshatch fashion.
- Wait up to 7-10 mins and buff off excess with a low-nap microfiber towel.
- Wait one hour and apply a second coat repeating the process (recommended, not required).
- Allow coating to cure for 2 hours before using the vehicle.

Specifications